N-Hydroxysuccinamide functionalized iron oxide nanoparticles conjugated with 5-flurouracil for hyperthermic therapy of malignant liver cancer cells by DNA repair disruption.

Magnetized iron oxide nanoparticles are ideal materials for biological and biomedical applications due to their biocompatibility, super paramagnetic behavior, surface capability, and chemical stability. This research article is narrating the overview of methodologies of preparation, functionalization, characterization and applications of Fe3O4 nanoparticles. Super paramagnetic nanoparticles are studied for their hyperthermia properties. The proposed mechanism behind the hyperthermia was damaging the proteins responsible for DNA repair thereby, directly accelerating the DNA damages on cancer cells by increasing the temperature in the vicinity of the cancer cells. In this study, super paramagnetic iron oxide (Fe3O4) nanoparticles (SPIONs) and anti-cancer drug, 5-fluorouracil, functionalized with N-Hydroxysuccinimide organic molecules. A specific absorption rate at 351 nm can be achieved using UV analysis. The magnetic Fe3O4 nanoparticles had a cubic crystalline structure. FE-SEM(field emission scanning Electron microscopy) with EDAX(energy dispersive X-ray analysis) analysis shows that the size of the SPION was about 30-100 nm range and the percentage of chemical compositions was higher in the order of Fe, O, C. for particle size analysis, the SPION were positively charged derived at +9.9 mV and its conductivity is measured at 0.826 mS/cm. In-vitro anti-cancerous activity analysis in Hep-G2 cells (liver cancer cells) shows that the 5-fluorouracil functionalized SPIONs have higher inhibition rate than the bare Fe3O4 nanoparticles. The Fe3O4 nanoparticles were studied for their hyperthermic abilities at two different frequencies such as 3.05 × 106 kAm-1s-1 and 4.58 × 106 kAm-1s-1.The bare Fe3O4 at low magnetic field, 10 mg was required to raise the temperature above 42°- 45 °C and at high magnetic field, 6 mg was enough to raise the same temperature. The 5-fluorouracil functionalized Fe3O4 shows that at low magnetic field, 6 mg is required to raise the hyperthermia temperature and at high magnetic field, 3 mg is required to raise the temperature above 42°- 45 °C. the rate of heating and the temperature achieved with time can be tuned with concentrations as well as magnetic component present in the Fe3O4 nanoparticles. Beyond this concentration, the rate of cell death was observed to increase. The saturation and low residual magnetization were revealed by the magnetization analysis, making them well suited for clinical applications.

MXenes - Versatile 2D materials for identification of biomarkers and contaminants in large scale environments - A review.

Recent years have seen a lot of interest in transition metal carbides/carbonitrides (MXenes), Which is one of newly proliferating two-dimensional (2D) materials.The advantages and applications of synthesizing MXenes-based biosensing systems are interesting. There is an urgent requirement for synthesis of MXenes. Through foliation, physical adsorption, and interface modification,it has been proposed that many biological disorders are related to genetic mutation. Majority of mutations were discovered to be nucleotide mismatches. Consequently, accurate -nucleotide mismatched discrimination is crucial for both diagnosing and treating diseases. To differentiate between such a sensitivealterations in the DNA duplex, several detection methods, particularly Electrochemical-luminescence (ECL) ones, have really been investigated.Mn+1XnTx is common name for MXenes, a novel family of two-dimensional (2D) transition metal carbides, nitrides, and carbonitrides, where T stands for interface termination units (i.e. = O, OH, and/or F). These electronic characteristics of MXenes may be changed between conductive to semiconducting due to abundant organometallic chemistry.Solid-state ECL sensors predicated on MXene would provide the facile nucleotide detection and convenience for usage with minimal training, mobility and possibly minimal cost.This study emphasizes upcoming requirements and possibilities in this area while describing the accomplishments achieved in the usage and employing of MXenes in the research and development of facile biomarkerdetection and their significance in designing electrochemical sensors. Opportunities are addressed for creating 2D MXene materials sensors and devices with incorporated biomolecule sensing. MXenes Carry out this process sensors, address the advantages of using MXenes and their variants as detecting materials for gathering different types of data, and attempt to clarify the design principles and operation of related MXene-based sensors, such as nucleotide detection, Single nucleotide detectors, Cancer theranostics, Biosensing capabilities, Gliotoxin detection, SARS-COV-2 nucleocapsid detection, electrochemical sensors, visual sensors, and humidity sensors. Finally, we examine the major issues and prospects for MXene-based materials used in various sensing applications.

A Brief Review of Graphene-Based Biosensors Developed for Rapid Detection of COVID-19 Biomarkers.

The prevalence of mutated species of COVID-19 antigens has provided a strong impetus for identifying a cost-effective, rapid and facile strategy for identifying the viral loads in public places. The ever-changing genetic make-up of SARS-CoV-2 posts a significant challenfge for the research community to identify a robust mechanism to target, bind and confirm the presence of a viral load before it spreads. Synthetic DNA constructs are a novel strategy to design complementary DNA sequences specific for antigens of interest as in this review's case SARS-CoV-2 antigens. Small molecules, complementary DNA and protein-DNA complexes have been known to target analytes in minimal concentrations. This phenomenon can be exploited by nanomaterials which have unique electronic properties such as ballistic conduction. Graphene is one such candidate for designing a device with a very low LOD in the order of zeptomolar and attomolar concentrations. Surface modification will be the significant aspect of the device which needs to have a high degree of sensitivity at the same time as providing a rapid signaling mechanism.

Ultrasensitive Detection of Dopamine, IL-6 and SARS-CoV-2 Proteins on Crumpled Graphene FET Biosensor.

Universal platforms for biomolecular analysis using label-free sensing modalities can address important diagnostic challenges. Electrical field effect-sensors are an important class of devices that can enable point-of-care sensing by probing the charge in the biological entities. Use of crumpled graphene for this application is especially promising. It is previously reported that the limit of detection (LoD) on electrical field effect-based sensors using DNA molecules on the crumpled graphene FET (field-effect transistor) platform. Here, the crumpled graphene FET-based biosensing of important biomarkers including small molecules and proteins is reported. The performance of devices is systematically evaluated and optimized by studying the effect of the crumpling ratio on electrical double layer (EDL) formation and bandgap opening on the graphene. It is also shown that a small and electroneutral molecule dopamine can be captured by an aptamer and its conformation change induced electrical signal changes. Three kinds of proteins were captured with specific antibodies including interleukin-6 (IL-6) and two viral proteins. All tested biomarkers are detectable with the highest sensitivity reported on the electrical platform. Significantly, two COVID-19 related proteins, nucleocapsid (N-) and spike (S-) proteins antigens are successfully detected with extremely low LoDs. This electrical antigen tests can contribute to the challenge of rapid, point-of-care diagnostics.

Detection of SARS-CoV-2 Virus Amplification Using a Crumpled Graphene Field-Effect Transistor Biosensor.

The rapid and unexpected spread of SARS-CoV-2 worldwide has caused unprecedented disruption to daily life and has brought forward critical challenges for public health. The disease was the largest cause of death in the United States in early 2021. Likewise, the COVID-19 pandemic has highlighted the need for rapid and accurate diagnoses at scales larger than ever before. To improve the availability of current gold standard diagnostic testing methods, the development of point-of-care devices that can maintain gold standard sensitivity while reducing the cost and providing portability is much needed. In this work, we combine the amplification capabilities of reverse transcriptase loop-mediated isothermal amplification (RT-LAMP) techniques with high-sensitivity end-point detection of crumpled graphene field-effect transistors (cgFETs) to develop a portable detection cell. This electrical detection method takes advantage of the ability of graphene to adsorb single-stranded DNA due to noncovalent π-π bonds but not double-stranded DNA. These devices have demonstrated the ability to detect the presence of the SARS-CoV-2 virus in a range from 10 to 104 copies/µL in 20 viral transport medium (VTM) clinical samples. As a result, we achieved 100% PPV, NPV, sensitivity, and specificity with 10 positive and 10 negative VTM clinical samples. Further, the cgFET devices can differentiate between positive and negative VTM clinical samples in 35 min based on the Dirac point shift. Likewise, the improved sensing capabilities of the crumpled gFET were compared with those of the traditional flat gFET devices.

Ultrasensitive detection of nucleic acids using deformed graphene channel field effect biosensors.

Field-effect transistor (FET)-based biosensors allow label-free detection of biomolecules by measuring their intrinsic charges. The detection limit of these sensors is determined by the Debye screening of the charges from counter ions in solutions. Here, we use FETs with a deformed monolayer graphene channel for the detection of nucleic acids. These devices with even millimeter scale channels show an ultra-high sensitivity detection in buffer and human serum sample down to 600 zM and 20 aM, respectively, which are ∼18 and ∼600 nucleic acid molecules. Computational simulations reveal that the nanoscale deformations can form 'electrical hot spots' in the sensing channel which reduce the charge screening at the concave regions. Moreover, the deformed graphene could exhibit a band-gap, allowing an exponential change in the source-drain current from small numbers of charges. Collectively, these phenomena allow for ultrasensitive electronic biomolecular detection in millimeter scale structures.

Energetically biased DNA motor containing a thermodynamically stable partial strand displacement state.

Current work in tuning DNA kinetics has focused on changing toehold lengths and DNA concentrations. However, kinetics can also be improved by enhancing the completion probability of the strand displacement process. Here, we execute this strategy by creating a toehold DNA motor device with the inclusion of a synthetic nucleotide, inosine, at selected sites. Furthermore, we found that the energetic bias can be tuned such that the device can stay in a stable partially displaced state. This work demonstrates the utility of energetic biases to change DNA strand displacement kinetics and introduces a complementary strategy to the existing designs.